Group Allocation - JUFLO LED TABLE EVENT TABLE Bedienungsanleitung

LED MODULE

2.3 Group allocation

Up to 4 groups can be controlled separately or together. Press
the „GROUP" button to select the group to be controlled. The
numbers 1 to 4 are backlit in red and indicate the selected
group. By long pressing the „GROUP" - key you control all
groups at the same time. To assign the LED Module to a re-
spective group, proceed as follows.
1. Activate the remote control by pressing any button. (This
is normally in sleep mode and activates for 5 minutes when
a button is pressed, thereby being able to receive and not
only send radio signals.)
2. Connect the LED Module to a USB power source. Watch out
for your remote now!
3. The set group on the remote control flashes. You can
change the group by pressing the Group key.
4. After 5 seconds, the group assignment mode switches
itself off and the LED Module is ready for operation in the
new group
Select group
Press the Group button on the remote control to select the
group you want to control. By long pressing the group key you
can control all groups at once.
34