Mounting/ Removing - JUFLO LED TABLE EVENT TABLE Bedienungsanleitung

2.1 Mounting LED module
On the top and bottom of the table is
a 6 cm large recess to place the LED
module there. On top of the table, first
thread the cable through the table top
into the metal base. When looking side-
ways into the hole you can look at the
ground. On the bottom, place the LED
module in the center of the hole provid-
ed. The modules each hold by magnet.
Removing the LED Module
— On the bottom you can simply pull off
the module.
— The upper LED module can be
removed from the underside of the
table! A hole allows insertion of
your finger to push the module up-
wards. Never try to remove the LED
module with a tool from the top.
This causes scratches and damage
to the tabletop.
ENGLISH
27