Product Description - Concept GE3911 Bedienungsanleitung

• Do not immerse the power cord, plug, or appliance into water or any other liquid.
• Check the appliance and power cord for damage regularly. Do not switch on a damaged unit.
• Turn the unit off, unplug the power cord from the wall outlet, and let the unit cool down before cleaning and
after use.
• Do not repair the appliance yourself. Contact an authorized service center.
Failure to follow the manufacturer's instructions may lead to refusal of warranty repair.

PRODUCT DESCRIPTION

1. Carrying handles
2. Grilling surface
3. Dripping bowl
4. Temperature controller
5. Heating indicator
6. Control module with electronics
NOTE
The unit is equipped with a non-stick surface, which enables the preparation of food with a minimum amount of oil
or fat.
Prior to using a new unit, wipe the surface and the inside with a wet cloth for hygienic reasons.
Then turn on the unit without food at maximum temperature for 20 minutes (see the Operating Instructions below).
It's possible that the unit will emit a slight smell and smoke, which should disappear after a while. Air the room well
during this process.
OPERATING INSTRUCTIONS
1. Put the deep fryer on a level and steady surface. Uncoil the whole supply
cable. Make sure it does not touch any close sources of heat.
2. Connect the removable control module to the heating body connector.
Make sure it has reached the stop (Fig. 1). An incorrectly mounted control
module cannot regulate the temperature accurately. This could lead to
overheating and destruction of the unit.
3. Set the temperature controller to the minimum and connect the fryer to
the mains.
4. The non-stick surface allows use without oil. If you still want to use oil,
spread the grilling surface with a very thin layer of oil or butter.
5. Select the required temperature according to the food. Information values
are provided in the table below.
18
4
5
6
EN
2 1
3
Fig. 1
GE3911