Herunterladen Inhalt Inhalt Diese Seite drucken

BaByliss BeLiss Brushing 1000 Gebrauchshinweise Seite 11

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 14
INSTRUCTIONS FOR USE
Preparing your hair before straightening or blow-drying
1. After shampooing your hair, towel dry and untangle it carefully with a large-toothed comb.
Advice from the hairstylist
Always start untangling your wet hair at the tips, then gradually work your way up. Gentle untangling prevents split ends from forming.
2. Pre dry your hair using the BE Liss brushing without attachment and leave it damp. (1)
Advice from the hairstylist
- To give your hairstyle more volume, pre-dry your hair with your head bent forward to lift the roots better.
- However, if you would rather have less volume, hold your head straight when pre-drying.
3. Work in steps:
• Use clips to separate your combed and untangled hair into sections about 2cm wide.
• Lift the upper sections of your hair and pin to the top of your head to begin with the sections of hair at the nape of the neck and
the sections underneath. Continue with the sections at the back of the head and then the sections on the side. Finish with the
sections on the top.
• Carefully work on the sections one at a time either with the straightening head, with the rotating head, with the smallest round
brush or with the diff user depending on the length of hair and the desired hairstyle.
Attaching and removing the accessories
Fit the heads (straightening or rotating) heads, the small round brush or diff user to the body of the dryer by lining up the guides
on the two parts and pushing together until you hear a click.
To remove the brush, press on the unlocking buttons located on the sides of the unit and gently pull the accessory off .
The 2 speeds and the 2 rotation directions of the rotating head
To wind the section of hair around the rotating head automatically, press the button to rotate right or left and maintain the pres-
sure while blow drying. Begin with speed 1, low power, to make sure the direction of rotation is correct. Then increase the speed
to 2 to create the desired blow-dry eff ect, under or out. Stop the rotation by releasing the button.
Using the Be Liss straightening head
Perfect straightening and lustre!
• Select the tension that's right for your hair using the Tensio Control System (1. waves, 2. loose curls, 3. tight curls, 4. very tight
curls). (2)
Advice from the hairstylist
- When using the unit for the fi rst time, select tension 1 (lowest tension) to become familiar with the BE Liss blow-dryer
- Then gradually increase the tension until you fi nd the setting that is most appropriate for your hair.
Caution! Regardless of the straightening you want, we recommend holding, with your other hand, the tips of the section of hair to
straighten so that the hair remains evenly distributed between the teeth of the straightening head. And, when straightening, make
sure you position the roots of the small section of hair at the base of the teeth of the comb, then slowly and steadily move the unit
down the section of hair while holding the tips of the section with your other hand. (3)
Straightening while increasing or reducing volume?
• To reduce the volume of thick hair, place the straightening combs on top of the section of hair and slide them slowly along the
section from roots to tips.
• To add volume to fi ne or fl at hair, place the straightening combs under the section of hair. It will straighten while lifting the roots
and giving your hair volume. (4)
• Repeat on all your hair and don't forget the cool-air shot to perfect the hold.
Volume eff ect at the roots
• Separate a 3cm section of hair and place the straightening comb under the section as closely as possible to the roots. Make sure
that the comb goes through your hair completely.
• Turn your BE Liss brushing about 45° while gently sliding it towards the tips. This rotating movement will give your roots a maxi-
mum of volume! (5)
• Repeat the operation if necessary and don't forget the cool-air shot on the section to perfect the hold.
Shaping
The BE Liss straightening head is also perfect for your daily 'quick comb': you have a stray section to tame, your hairstyle lacks
oomph, etc. In just 2 minutes, you will return shine and volume to your hairstyle using the same techniques described above, but
this time on dry hair.
An ideal companion when you're on the move!
11

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis