Assembly - Powerfix Profi Z31780 Bedienungs- Und Sicherheitshinweise

operations. The dust mask or respirator must
be capable of filtrating particles generated
by your operation. Prolonged exposure to
high intensity noise may cause hearing loss.
CAUTION! DANGER OF INJURY! En-
sure that you do not come into contact with
the cutting disc while working.
Always use the cutting disc safety guard
Use this product only with angle grinders
that have a suitable metal protective guard
around the disc (see Fig. A).
Position this protective guard on the grinder
in such a way that the lower part of the ro-
tating cutting disc is uncovered and the
grinder's protective guard cannot come into
contact with the workpiece.
CAUTION! DANGER OF
FIRE! Cutting metal creates
sparks. Ensure that there are no
ignitable materials in the working area.
Sparks can damage paint, glass and other
surfaces. Do not wear clothing made of ny-
lon or polyester; wear suitable, non-inflam-
mable working clothes.
Ensure that the workpiece is held firmly in
place and lies tightly against the base plate.
Do not use the product on workpieces that
are too large, otherwise they cannot be held
firmly in middle of the vice.
Check before and regularly during use that
the screws, bolts and other fixings are firmly
seated.
Check the product regularly for damage. Vi-
brations can loosen screws, bolts and other
fixings during use.
Never use your product if you discover that
it is damaged in any way.
Ensure that the cutting disc of your angle
grinder is mounted at right angles to the
base plate.
Use cutting discs only and not roughing
discs in this product.
Check the cutting disc of your angle grinder
regularly for damage.
Never use a disc if you discover it has any
dents, nicks or other damage. It could disin-
tegrate.
8 GB/IE/NI
Do not allow parts of your body to come
within working range of the cutting disc until
after it has come to a standstill.
When cutting follow the instructions of the
manufacturers of the electrical power tool
and the cutting disc.
Use angle grinders that have a cutting disc
. diameter of 115 or 125 mm only.
5
Do not allow anyone else to
come within the working range of
the product while you are using it.
Grip the handle tightly when using the angle
grinder and position your body and arm to
allow you to resist kickback forces.
Do not "jam" the wheel or apply excessive
pressure. Do not attempt to make an exces-
sive depth of cut. Overstressing the wheel
increases the loading and susceptibility to
twisting or binding of the wheel in the cut
and the possibility of kickback or wheel
breakage.
When the wheel is binding or when inter-
rupting a cut for any reason, switch off the
power tool and hold the cutting unit motion-
less until the wheel comes to a complete stop.
Never attempt to remove the wheel from the
cut while the wheel is in motion otherwise
kickback may occur. Investigate and take
corrective action to eliminate the cause of
wheel binding.
Do not restart the cutting operation in the
workpiece. Let the wheel reach full speed
and carefully re-enter the cut. The wheel may
bind, walk up or kickback if the power tool
is restarted in the workpiece.

Assembly

CAUTION! DANGER OF FIRE! Assem-
ble and use the product on a fire-resistant sur-
face only.
Follow these steps:
Fasten the saddle
with the hexagonal socket head screws
20
and washers
23
on to the base plate
21
(see Fig. A).
22