Technical Data; Safety Advice; General Safety Advice - Powerfix Profi Z31780 Bedienungs- Und Sicherheitshinweise

Rotary adjustment knob (vice) x 1
14
Vice adjustment thread (vice) x 1
15
Guide bolt (vice) x 1
16
Stop (vice) x 1
17
Stop (vice rear jaw) x 1
18
Hexagonal socket head screw (fastening of
19
mounting piece) x 2
Base plate x 1
20
Saddle x 1
21
Washer (hexagonal socket head screw
22
saddle) x 2
Hexagonal socket head screw (fastening of
23
saddle) x 2
Mount x 1
24
Clip x 1
25
Rear mounting piece x 1
26
Wing screw x 1
27
Allen key x 1
28
Wrench x 1
29

Technical data

Max. dimensions of the workpiece:
Tubes: round tube: 30 x 2 mm (ø x t)
other shapes: 30 x 2 mm (W x t)
Bars: round bar: ø 12 mm
other shapes: 12 mm (W)
Plates: 45 x 2 mm (W x t)
Material / Weight:
Material: Cast aluminium, cast iron (main
material)
Weight: 2.9 kg (±5%)

Safety advice

Read all the safety ad-
vice and instructions. Failure to observe the
safety advice and instructions could result in elec-
tric shock, fire and/or serious injury.

General safety advice

DANGER OF LOSS OF LIFE
AND ACCIDENT TO IN-
FANTS AND CHILDREN!
Never leave children unsupervised with the
packaging materials. Packaging materials
present a suffocation hazard. Children often
underestimate danger. Always keep the
product out of reach of children. This prod-
uct is not a toy.
Keep your working area clean and well lit.
Untidy or poorly lit working areas can lead
to accidents.
Store the product in dust-free and dry condi-
tions.
To avoid danger to life from
electric shock!
Ensure that the mains lead does not enter
the working area of the disc or lie within
range of flying sparks.
Always keep the angle grinder's mains lead
in place using the clip
Always pull your angle grinder's mains plug
out of the mains socket before you carry out
any cleaning or adjustment of your product.
Avoiding the danger of injury
and/or damage to property!
While working with your angle
grinder always wear protective
glasses, hearing protection and
safety gloves, and if necessary a hairnet
(with long hair) and a dust mask (depending
on the materials being cut).
Do not wear loose clothing while you are
working with your product.
Fasten the product through the fastening
holes down on to a workbench / table. En-
sure that the workbench / table and the
product are stable.
The eye protection must be capable of
stopping flying debris generated by various
(see Fig. C).
25
GB/IE/NI 7