Prompts And Error Messages - ACKERMANN BlueBee Serie Originalbetriebsanleitung

1 0 . P RO M P TS A N D E R RO R M E S SAG E S
Caution: If an error message appears, first switch off the appliance and then disconnect from
the power supply. Check the connections, water supply and drain lines as well as the stop valves.
Then connect the appliance to the power supply again. If the error message continues, contact
an authorised service partner immediately.
P RO M P TS A N D E R RO R M E S SAG E S
E1
E2
E3
E4
E5
E6
E7
E8
E9
E21
E22
E98
E99
SAF ESF
SAF ESL
SLt
dEt
brL
Sru
Abr
reG
10
Check rinsing system
Check drain system – timeout
Check boiler heating – timeout
Check tank filling – timeout
Check tank sensor – value too low
Check tank sensor – value too high/short circuit
Check boiler sensor – value too low
Check boiler sensor – value too high/short circuit
Check boiler filling – timeout
Check rinsing – timeout
Check tank heating – timeout
Check soft start – malfunction
Motherboard / connection error
Safety thermostat triggered
Check tank level – value too high/low
Salt level low – refill soon
Detergent suction tube empty level
Rinsing agent suction tube empty level
Service/
cartridge replacement due
Abort cycle – restart
Resin regeneration in the background
To reset the service cycle counter: switch off the machine, open
the door and press and hold down all three buttons for 4 seconds.