Electrical Installation And Connection; Disposal; Technical Data - ACKERMANN BlueBee Serie Originalbetriebsanleitung

5 . E L E C T R I C A L I N STA L L AT I O N A N D CO N N E C T I O N
Caution: The electrical installation of the dishwasher must be carried out in conformity with the
standards by a specialist electrical company authorised by the energy supplier responsible.
Caution: The on-site power supply disconnection device (mains switch) has to be switched off
for the dishwasher to be disconnected and de-energised.
Check that the line voltage corresponds to the information on the dishwasher's rating plate.
According to the specifications, a power supply disconnection device (mains switch or isolation
switch) as well as a ground fault circuit interrupter (GFCI) must be installed in the electrical supply
line. The power consumption of these switches must have been measured, they must be discon-
nected at all phases and have a contact distance of at least 3 mm.
Connect the dishwasher to the on-site equipotential bonding system. The connection terminal is
located at the back of the appliance. If the dishwasher is placed on a base or substructure, the
dishwasher must be grounded with the base (equipotential bonding).
Changes to the connection line or its use may only be made by the manufacturer, their customer
service representative or a similarly qualified person.
6. D I S P O SA L
Contact your dealer so that the material contained in the dishwasher can be recycled where pos-
sible.
7 . T E C H N I C A L DATA
See rating plate (on the right side panel)
4