Daily Operation Of The Dishwasher; Switching On The Dishwasher; Washing - ACKERMANN BlueBee Serie Originalbetriebsanleitung

9 . DA I LY O P E R AT I O N O F T H E D I S H WA S H E R
a. Switching on the dishwasher
Before switching on the dishwasher, check that the on-site water valve is open and that the
mains switch is switched on (this is indicated by the horizontal bars visible in the disherwasher's
display panel (4)). Then check that there is sufficient detergent and rinsing agent in the canisters
and storage tanks.
Insert the pump suction strainer and strainer(s), close the door and press the ON/OFF button
(1) to switch on the dishwasher.
The dishwasher first runs through several drainage cycles. The boiler and tank are then filled
with water. The LEDs in the status and progress indicator bar (5) flash progressively from the
top to the bottom while the dishwasher is filling and heating up. This procedure can take up to
45 minutes depending on the type of dishwasher and the power connection. Afterwards, the se-
cond LED in the status and progress indicator bar (5) shows a constant green light.
b. Washing
As soon as the machine is ready for operation (LED in the status and progress indicator bar (5)
shows a constant green light), a wash program can then be started. Please follow the information
below when filling the baskets with items:
Washing dishes and cutlery
• Scrape off heavy food residue or rinse it off with cold to lukewarm water. Soak dishes with
burnt-on residue beforehand.
• Remove any paper residue.
• Stack plates with their upper side facing forward.
• Arrange cups, glasses and pans with the opening facing down.
• Place the cutlery standing up in cutlery baskets or lying down in a level basket. Make sure
that the cutlery is well spaced and avoid overloading the basket. Soak the cutlery prior to

washing.

• Place knives and other sharp and pointed cutlery items with the handles upwards in the
cutlery baskets to avoid injuries.
• Do not empty water back into the appliance (e.g. if items have turned over during washing)
Washing glasses
• Pour out beverage residue (not into the machine).
• Remove any paper residue.
• Rinse off ash with water.
• Arrange the glasses with their opening facing down.
• Space the glasses to prevent them from rubbing against each other. This will avoid scratches.
• For tall glasses, choose a basket with appropriate divisions, so that the glasses are held in a
stable position.
• Do not empty water back into the appliance (e.g. if items have turned over during washing)
8