Displaying Information; List Of Viewable Messages; End Of Shift - ACKERMANN BA U 530 Bedienungsanleitung

UK
•
Rinse the area around the salt cap by hand and run a self-cleaning cycle to avoid any risk of
corrosion.
•
The 'SLT' warning will disappear after a few minutes.
The warning rEG on the display indicates that the machine is running a resin regeneration cycle,
needed to ensure the correct operation of the water softener; while this warning is shown, the cycles
run could be longer than usual.
N.B. Do not switch off the machine if a regeneration cycle is underway
Door open
Rinse temperature
Wash temperature
Short wash
Medium wash
Long wash
•
At the end of the day always drain the machine as described in the section Machine draining.
•
Disconnect the power supply by means of the main switch and close the external water cock.
•
Perform routine maintenance and clean the machine as described in the section Maintenance.
•
If possible, leave the door open to prevent bad odours building up inside the machine.
Page 8 of 12
INSTRUCTION MANUAL FOR DISHWASHERS
With the dishwasher on, press PROGRAMME SELECTION (2) for five
seconds, in sequence the following are shown:
•
"t" wash temperature
•
"b" rinse temperature
•
"CC" wash cycles carried out during the life of the dishwasher.

4.11 Displaying information

4.12 List of viewable messages

Number of cycles carried out
End of cycle
Automatic start enabled
Continuous wash
Final drain
Regeneration cycle or request
No salt in the softener

4.13 End of shift