Siemens SIMATIC HMI Kurzanleitung Seite 2

SIMATIC HMI
Mobile Panels 2nd Generation
Quick Install Guide
Product Information
Validity
This product information is valid for the "Mobile Panels 2nd Generation" HMI devices with the article numbers specified under "Required system components".
This product information describes the general commissioning of the Mobile Panels 2nd Generation HMI devices. Before setting up and commissioning the system, refer to the
"Mobile Panels 2nd Generation" operating instructions for a description of the safety functions of fail-safe HMI devices and other information. You can find the operating instructions on the
supplied DVD and on the Internet (https://support.industry.siemens.com/cs/ww/en/ps/14746/man).
Required system components
Mobile Panel 2nd Generation HMI device
Article numbers 6AV2125-2....-0AX0
You can find ordering information on the Internet (https://mall.industry.siemens.com).
Installing connection boxes
Use the product information provided for the connection box.
1. Mount the connection box.
2. Set a unique box ID.
3. Connect the protective conductor.
4. If you are installing a hard-wired F-system, connect the cables for the EMERGENCY STOP button and
acknowledgment button with your processing unit.
5. Connect the connection box with PROFINET (LAN).
6. Connect the cables for the power supply.
Connecting the connecting cable to the Mobile Panel
1. Insert a
SIMATIC HMI
memory card if
required.
Connecting the Mobile Panel
Transferring a project
Note
The following applies to KTP F Mobile safety devices: Configure the PROFIsafe address of the HMI device in the Control Panel before the project transfer. The PROFIsafe address in the
Control Panel must correspond to the PROFIsafe address of the HMI device in the project.
1. Connect the configuration PC with the LAN.
2. To transfer the project, proceed according to the description in the "Mobile Panels 2nd Generation" operating instructions or in the online help for WinCC (TIA Portal).
Siemens AG Division Digital Factory
Postfach 48 48, 90026 NÜRNBERG
KTP Mobile connecting cable
Article numbers 6AV2181-5AF..-0AX0
2. Connect the
connector of the
cable to the X1 and
X80 interfaces in the
connection
compartment.
Connection box compakt, connection box standard or connection box advanced
Article number 6AV2125-2AE03-0AX0, 6AV2125-2AE13-0AX0 or 6AV2125-2AE23-0AX0
Repeat steps 1 to 3 for each connection box that you operate with a fail-safe HMI device.
3. Close the
connection
compartment. The
maximum
permissible torque
is 0.2 Nm.
Quick Install Guide
A5E33878488-AA, 06/2015