Maintenance - 3M Elixair SkyMill Revolution Sicherheits- Und Bedienungshandbuch

5) Re-sharpening a SkyScraper
To re-sharpen a SkyScraper, lightly insert it into the port for a few seconds
as shown. For best results, apply frequent light pressure until sharp.
CAUTION: Only use SkyScrapers specifically recommended for
this tool.
CAUTION: Use a surface cleaning wipe to remove any surface
contaminants from the SkyScraper before inserting it into the
SkyMill Revolution.
CAUTION: Continuous excessive force will cause the SkyMill
Revolution to overheat and could potentially reduce the life
of the device.
CAUTION: Re-sharpened SkyScrapers are extremely sharp and
may cause personal injury. Wear appropriate personal protective
equipment when using the SkyMill Revolution and SkyScrapers.
6) Turning off the SkyMill Revolution
Turn off the SkyMill Revolution using the power button at the top of the
product to save power while not in use.

7) Maintenance

For optimum performance, 3M SkyMill Revolution by Elixair must be cleaned
and charged regularly. To minimise exposure to dust during cleaning, the
SkyMill Revolution should be securely attached to a dust-free vacuum hose
to the waste removal port as shown. Proper dust extraction can reduce dust
related hazards and damage to the device.
WARNING: to reduce the risk of injury, always unplug the charger
before performing any maintenance. Never disassemble the
tool or the charger. Do not attempt to replace the battery pack.
Battery pack is not removable, and use of any other battery
packs may create a risk of injury and fire. Replacement of battery
pack by user will null and void the warranty. For repairs and
servicing, please refer to the service section within the general
power tool safety warnings section of this manual.
WARNING: Dust can be highly combustible.
CAUTION: Ensure waste removal access flap is sealed securely
during use.
8
5
6
7