Troubleshooting - SUNTEC Klimatronic DryFix 10 Pure Bedienungsanleitung

Technical data
SPECIFICATION
DEHUMIDIFICATION (litre/day,
30°C and RH 80%)
CURRENT
VOLTAGE
POWER
REFRIGERANT
UNIT DIMENSIONS

Troubleshooting

Problem
The unit does not work.
The device does not
dehumidify.
The air does not flow out. Is the air filter dirty?
Loud noises during start
up.
MODEL
DryFix 10 Pure
10 l
1,4 A
220-240V / 50Hz
280 W
R290
276 x 480 x 185 mm
Possible cause
Is the unit plugged in?
Does the water tank indicator
(water tank is full or misplaced)
light up?
Is the ambient temperature
higher than 35 ° C or lower than
5 ° C?
Is the air filter dirty?
Is the air inlet or outlet blocked?
If the device was placed awry or
unstable?
Is the air filter dirty?
DryFix 20 Pure
20 l
2,0 A
220-240V / 50Hz
380 W
R290
276 x 500 x 235 mm
Solution
Plug in the unit.
Empty the water tank and set it
to the correct position again.
The heat protection has been
activated, the device cannot be
operated.
Clean the air filter as described
in the manual.
Check the air inlet and outlet
and remove any obstructions.
Clean the air filter as described
in the manual.
Place the unit on a stable flat
surface.
Clean the air filter as described