Cleaning The Underside; Blades; Blade Replacement - Mowox RM 600 Li BT Originalbetriebsanweisung

better if clean and sharp - but note: When cleaning the blades, please switch off the main
power switch and use protective gloves.
Never use a high-pressure cleaner or flushing water for cleaning.
Cleaning the mower body
The robot mower is battery powered - so take care when cleaning. Use a soft brush and/
or a damp cloth with usual household detergent. Wipe off any residues after cleaning.

Cleaning the underside

Ensure t h e m a i n power switch is in
the robotic mower onto its side to expose its underside, clean the blade disc and frame,
using a soft brush or damp cloth. Rotate the blade disc to make sure that it moves
freely, and check that the blades can turn on their bearings.
Clean the contact pins and the charging strips
Use metal cleaner or very fine-grade emery paper to clean the contact pins and the
charging strips on your mower/ charging station. Remove any debris, leaves or grass
clippings around the contact pins and charging strips to ensure efficient charging.
7.4 B
LADES
about the blades
WARNING
!
Ensure the robotic mower is completely shut off and wear protective gloves
before cleaning, adjusting or replacing the blades.
WARNING!
To ensure maximum cutting efficiency and safety, always use the original
manufacturer replacement blades and blade mounting parts when replacing.
There are three blades on your mower which are mounted onto the blade disc. These
blades can last up for 3 months (if no obstacles have been hit). Please remember to
replace all three blades at the same time for best balance and cutting performance.

Blade replacement

Use a screwdriver to remove each of the mounting screws and blades. Then replace
each blade and firmly re-screw. Please make sure your newly assembled blades can spin
freely.
Rev 7
OFF
position and wear protective gloves. Turn
37 (EN)