Installation In The Soil - Mowox RM 600 Li BT Originalbetriebsanweisung

Attach the boundary wire onto your lawn with pegs, this makes adjustments to the
boundary wire possible during the first few weeks of operation.
Place the boundary wire firmly onto the soil, under the grass, and fasten it to the ground
with the consigned pegs. Make sure that the mower cannot cut the wire at any spot.

Installation in the soil

Dig the boundary wire in to a maximal depth of 5 cm if you want to scarify or aerate the
lawn with a separate appliance. This avoids the wire to be destroyed by that appliance.
Install the boundary wire with a distance of maximum 1,00 metre between the pegs.
Dry ground?
Hard or dry ground may cause pegs to break when driving them in. Water the lawn if it is
very dry prior to the wire installation.
Cut boundary wire and consequential damage are not subject to
Distance boundary wire – garden edge
When the robotic mower approaches any boundary wire, the sensors which are installed in
front part of the mower detect it. But before turning around, the robotic mower overruns
the boundary wire by approximately 30 cm. Respect this when you create the layout of
your boundary.
Obstacles higher than 100 mm
Fixed obstacles higher than 100 mm, such
as trees, walls, fences, garden furniture,
etc, are recognized by the crash sensors.
Th e robot will stop, drive backward and
then turn around to cut in another
direction .
Soft, unstable and precious obstacles must
Rev 7
warranty.
≥ 30cm
15 (EN)
>
100 mm