Programming - Mowox RM 600 Li BT Originalbetriebsanweisung

1. You press the Home button and close the LCD cover.
2. The battery capacity decreases to less than 30%. After a full charge, it will go back to
work or wait for remain in the base station until the next worktime window is reached.
3. The red LED indicator on the station indicates the battery is on charging.
4. The constant green LED indicator on the station indicates the battery is fully charged. If
in the scheduled working time, the mower will leave the station and start the automatic
working process; otherwise it will stay on the station.
If your robot mower, for some reason, cannot return to the charging station, it will try
again by returning to the lawn area and find the boundary wire, then follow the same
procedure.
If the battery temperature is higher than 45° C, the device will stop charging to protect
the battery. After the temperature has been reduced, charging will automatically restore.
If the mower system control board temperature is higher than 90° C, the robotic mower
will stop work, and go back to charging station. After the temperature has been reduced,
the work process will restore according your settings.
If the battery power is fully consumed while the device has not driven to the charging
station, the mower cannot be started (the screen keeps off). Please take the robot back
to the station and put it on the charging position; keep the main power switch ON. The
mower will be charged automatically.
6. P
ROGRAMMING
PLEASE SET DATE AND TIME AS THIS IS THE BASE FOR THE
Rev 7
HOME
REST OF THE PROGRAMMING!
24 (EN)