Herunterladen Inhalt Inhalt Diese Seite drucken

Thermal Cover Maintenance; Special Maintenance; Winter Inactivity - Jacuzzi VIRTUS Bedienung Und Wartung

Vorschau ausblenden Andere Handbücher für VIRTUS:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 39
1
Turn the lever on the selector valve to "BACKWASH".
Reconnect the power supply to the hot tub via the main
switch on the power supply line.
Leave the filtering pump in operation for a few minutes.
Note: if the hot tub water level falls below the optimum level, LL
shows on the display: disconnect the power supply and top up the
water to the correct level.
If L2 is shown on the display, the solenoid valve is activated to re-
store the water level in the balance tank (this increases the time
needed for the backwash).
When the drainage water is clean, disconnect the power
supply.
Turn the lever on the selector valve to "FILTRATION".
Remove the connection to the drain and refit the cap.
2
Power the tub again; if the message LL shows on the display,
add water to the hot tub until the message disappears.
NOTE: if, despite running the backwash, the drain water is
dirty, replace the filter material (sand, polyester flakes, etc.).
Please see the installation manual.

THERMAL COVER MAINTENANCE

General cleaning
Remove the dirt with a brush.
Wash with a jet of water.
Clean the cover surface with a mild soapy water solution, us-
ing a soft-bristled brush.
Rinse thoroughly with water, removing any detergent resi-
due.
Leave to dry in a well-ventilated place in the shade.
Stubborn stains and mould
We recommend contacting an authorized Jacuzzi® service centre.

SPECIAL MAINTENANCE

For all special maintenance work, we recommend contacting
an authorised Jacuzzi® service centre, providing the following
information:
- model;
- purchase date;
- serial number (shown on the warranty certificate).
Model _______________________________
Purchase date __________________________
Serial number __________________________

WINTER INACTIVITY

In areas where winter temperatures frequently drop below 0°C,
during periods in which the hot tub is not used, proceed as follows:
Disconnect the power from the main electric board (and the
Jacuzzi® heat pump where used).
Empty the hot tub fully via the drain valve and leave it open.
When emptying the hot tub, not all of the water can be drained.
Stagnant water on the seats and bottom of the tub can be removed
using a sponge; water left in the hoses can be sucked out through
24

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Virtus pro

Inhaltsverzeichnis