Notes On Safety; General Information - Omron HBP-1120 Gebrauchsanweisung

Notes on Safety
The warning signs and symbol examples indicated below are intended to
ensure safe use of the product and prevent damage and injury to you and
others. The signs and symbols are explained below.
Safety Symbols used in this Instruction Manual
Indicates the matters in which death or severe bodily
Warning
damage may arise as a result of incorrect handling.
Indicates the matters in which bodily harm or material
Caution
damage may arise as a result of incorrect handling.
Note:
Indicates general information to keep in mind when using the unit and
other useful information.
Storage/Setup
Warning
• Install the unit in a location close to a power outlet where the AC adapter
can be easily disconnected. If the power cannot be quickly disconnected
when an abnormal condition occurs, an accident or fire may result.
• Do not use the cuff or AC adapter to lift the unit, it can also cause the
unit to malfunction.
• If the unit has broken down, contact your OMRON retail dealer or distributor.
• Do not use in combination with a hyperbaric oxygen therapy device, or
in an environment where combustible gas may be generated.
• Do not use in combination with magnetic resonance imaging (MRI) equipment.
If MRI is to be performed, remove cuff connected to the unit from the patient.
• Do not use with a defibrillator.
• Do not install the unit in the following locations:
- Locations subject to vibration such as ambulances and emergency helicopters.
- A location where there is gas or flame.
- A location where there is water or steam.
- A location where chemicals are stored.
• Do not use at extremely high temperature, high humidity, or high
altitude. Use only within the required ambient conditions.
• Do not subject the unit to intense shock.
• Do not place heavy objects on the AC adapter cable, or allow the unit to sit on the cord.
• Clinical testing has not been conducted on newborn infants and
pregnant women. Do not use on newborn infants and pregnant women.
• Do not plug in or unplug the AC adapter with wet hands.
• During measurement, make sure that no mobile phone or any other electrical
devices that emit electromagnetic fields is within 30 cm of this monitor. This may
result in incorrect operation of the monitor and/or cause an inaccurate reading.
General Information
EN
3