eta Laura Bedienungsanleitung Seite 24

GB
The following data will start to show after a few seconds:
1. – Weight in set units
2. – Body fat contents in % (fat) + analysis colour signalization (blue=underweight;
green=normal; red=overfat, obesity)
3. – Body water contents in % (TBW)
4. – Musculature contents in % (
5. – Bone weight contents in kg (
6. – BMI (Body Mass Index)
7. – Daily kilocalorie requirement (KCAL)
The results will display in a cycle. After three repetitions, the scale will automatically turn off.
There must not be a contact between feet, calves or thighs. Otherwise the measurement
For a repeated analysis of body characteristics (after saving the input data of the person
to the memory – e.g. 1), proceed as follows:
1) Press the button (if you were using the scale in the regular weighing mode).
2) Wait for 0.0 on the display or choose the number of memory with the
where your setting is saved.
3) Do not press anything after selecting the respective number of memory (wait till 0.0
appears). Step on the scale and your weight and bodily characteristics will begin to be
analyzed.
The scale is switched on automatically if you do not step on it within approx.
10 seconds after „0.0" is displayed. The scales can be turned off also by pressing the
Error messages and their symbols
Symbols displayed
LO
Err2
Err
V. TROUBLESHOOTING OF POSSIBLE PROBLEMS
If you have problems with weight:
– Check whether the batteries are inserted properly.
– Check whether you selected the proper weight unit.
– Check whether the scale is on a flat floor and they do not touch the wall.
– If nothing appears on the scale when you want to switch them on by tapping on them
or if „Lo" appears only, replace the battery.
)
)
Notice
could be inaccurate.
Note
button
Battery is dead
Very low % of fat
Very high % of fat
The measured weight is higher than maximum allowed value
of the scale.
.
Interpretation
24 / 51
or button