Advice On Disposal - Ufesa PV1530 Gebrauchsanleitung

5 CLEANING

ADVICE ON DISPOSAL:

Our goods come in optimised packaging. This
basically consists in using non-contaminating materials
6
which should be handed over to the local waste
disposal service as secondary raw materials.
This product complies with EU Directive 2002/96/CE.
The crossed wheelie bin symbol shown on the
appliance indicates that when it comes to dispose of
the product it must not be included in with household
refuse. It must be taken to a special refuse collection
7
point for electric and electronic appliances or returned to the
with
distributor when purchasing a similar appliance. Under current
alc3»
refuse disposal regulations, users who fail to take discarded
appliances to special refuse collection points may be
penalised. Correct disposal of discarded appliances means
that they can be recycled and processed ecologically, helping
stem
the environment and allowing materials used in the product
to be reused. For more information on available waste
disposal schemes contact your local refuse service or the
shop where the product was purchased. Manufacturers and
ticles
importers are responsible for ecological recycling, processing
ately
and disposal of products, whether directly or via a public
system.
re to
Your local town council can provide you with information
about how to dispose of obsolete appliances.
hold
e the
le or
ping,
until
Problem
The iron does not heat.
e the
ping
«anti-
uced
Display light flashes and only
shows «OFF»
The clothes tend to stick.
8
Water comes out together with
s left
steam.
After
r the
h the
Steam does not come out.
while
n its
h the
n
Spray does not work.
9
cally
Water comes out from the
soleplate before connecting
the iron.
10
Smoke comes out when
connecting the iron for the first
time.
11
Probable cause
1. Temperature control in very low
position.
2. No mains supply.
1. Auto shut-off function enabled
1. Very high temperature.
1. Temperature regulator in very low
position.
2. Steam regulator in very high position
with low temperature.
1. Steam regulator in closed position.
2. Temperature regulator in very low
position
3. No water in the tank.
4. Obstructed mechanism.
1. No water in the tank.
2. Obstructed mechanism.
1. The steam regulator is not properly
closed.
1. Lubrication of some of the inner
parts.
Solution
1. Turn to a higher position.
2. Check with another appliance or plug the iron
into a different socket.
move the iron about gently
1. Turn the temperature to a lower temperature.
1. Turn the temperature regulator to a higher
position
2. Turn the steam regulator to a lower position.
1. Turn the steam regulator to an open steam
position.
2. Turn the temperature regulator to a steam
position
3. Fill the tank.
4. Remove the needle and clean it, if this does not
help, contact the Technical Service.
1. Fill the tank.
2. Contact the Technical Service.
1. Make sure to place the steam regulator in
position .
Do not forget to empty the tank when you have
finished ironing.
1. Do not worry. It will disappear in a short period
of time, after the first usage.