Product Disposal - Ufesa STEAM TECH 2800 Bedienungsanleitung

TROUBLESHOOTING
PROBLEM
SOLEPLATE IS NOT
HEATING EVEN
THOUGH IRON IS
TURNED ON.
IRON DOES NOT
PRODUCE STEAM
SPRAY FUNCTION
DOES NOT WORK
STEAM JET AND
VERTICAL STEAM JET
FUNCTION DOES NOT
WORK
THE IRON LEAKING
WHITE STREAKS
COME THROUGH
THE HOLES IN THE
SOLEPLATE

PRODUCT DISPOSAL

This product complies with European Directive 2012/19/EU on electrical and electronic
devices, known as WEEE (Waste Electrical and Electronic Equipment), provides the le al
framework applicable in the European Union for the disposal and reuse of waste electronic
and electrical devices. Do not dispose of this product in the bin, instead oin to the elec-
trical and electronic waste collection centre closest to your home.
We hope that you will be satisfied with this product.
20
POSSIBLE CAUSE
Connection problem
Temperature control is in MIN
position
Not enou h water in tank
Steam control is selected in
non-steam position.
Selected temperature is lower
than that specified to use with
steam.
Not enou h water in tank
Steam jet function was used
very frequently within a short
period.
Iron is not hot enou h
The temperature settin is too
low to produce steam.
The soleplate has a build-up
of scale because it has not
been self-cleaned re ularly.
SOLUTION
check main power supply cable,plu and
outlet.
select adequate temperature
Fill water tank
Set steam control between positions of
minimum steam and maximum steam
(see "iron chart").
Select a hi her temperature
Fill water tank
Put iron on horizontal position and wait
before usin steam jet function.
Adjust to hi her temperature to steam
ironin .Put iron in vertical position and
wait temperature indicator li ht becomes
fixed.
The variable steam knob must be set
on"0"position until the iron is hot.
Do the self-cleanin process. Remember
to do it at least every two weeks.