System Setup; Device Setup - smith&nephew RENASYS GO Bedienungsanleitung

EN

5. System setup

There are times when you will need to disconnect from your device, such
as when you shower or wash, or when your canister needs to be replaced.
Your device is electrical and cannot come into contact with water. To
avoid exposure, power off the device and disconnect the dressing tubing
from the canister tubing before showering or washing. You will need to
reconnect your dressing tubing to the canister tubing and power on the
device as soon as you finish showering or washing.
The clear film placed on top of the wound and the dressing tubing are
water resistant. You can shower or wash with dressings in place, as long
as you do not soak them.
The following sections walk you through the steps to setting up
various components of the system:

Device setup

Power the device on. If the device is set to the CONTINUOUS mode, you
should have constant therapy delivered.
If the device is set to INTERMITTENT therapy, your therapy will cycle on for
5 minutes and off for 2 minutes.
Note: Your device will be set to Home Healthcare Use mode by your
healthcare provider, and the therapy settings cannot be changed. The
device may be Powered off to temporarily stop therapy (e.g. patient
shower, dressing change, etc). When re-started, the device will operate
using the settings set up by the healthcare provider.
19