Indoor Unit; Outdoor Unit; Installation Instructions - Lennox RELAX 24 Installationsanleitung

INSTALLATION OF INDOOR UNIT AND OUTDOOR UNIT
Read completely, and then follow step by step.

Indoor unit

•
Do not expose the indoor unit to heat or steam.
•
Select a place where there are no obstacles in front or
around the unit.
•
Make sure that condensation drainage can be
conveniently routed away.
•
Do not install near a doorway.
•
Ensure that the space on the left and right of the unit is more than 12cm.
•
Use a stud finder to locate studs to prevent unnecessary damage to the wall.
•
A minimum pipe run of 3 metres is required to minimise vibration & excessive noise.
•
The indoor unit should be installed on the wall at a height of 2.3 metres or more from the
floor.
•
The indoor unit should be installed allowing a minimum clearance of 15cm from the
ceiling.
•
Any variations in pipe length will/may require adjustment to refrigerant charge.

Outdoor unit

•
If an awning is built over the outdoor unit to
prevent direct sunlight or rain exposure,
make sure that heat radiation from the
condenser is not restricted.
•
Ensure that the clearance around the back of
the unit is more than 30cm and left side is
more than 30cm. The front of the unit should
have more than 200cm of clearance and the
connection side (right side) should have
more than 60cm of clearance.
•
Do not place animals and plants in the path of the air inlet or outlet.
•
Take the air conditioner weight into account and select a place where noise and vibration
will not be an issue.
•
Select a place so that the warm air and noise from the air conditioner do not disturb
neighbours.
Rooftop installation:
•
If the outdoor unit is installed on a roof structure, be sure to level the unit. Ensure the roof
structure and anchoring method are adequate for the unit location.
•
Consult local codes regarding rooftop mounting.
•
If the outdoor unit is installed on roof structures or external walls, this may result in
excessive noise and vibration, and may also be classed as a non serviceable installation.
3

Installation instructions

Fig. 2