Siemens CT636LE.1 serie Gebrauchsanleitung Seite 56

en Simple troubleshooting
Problem
Display shows
"12:00"
Display shows
"Milk container
connected?"
despite connected milk
container�
Display shows
"Overvoltage or
undervoltage"
Display shows
"Leave device to cool"
Display shows,
for example:
"Fault: E0510"
Display shows
"Fill bean container"
although the container
is already full, or the
grinder is not grinding
any beans�
Display shows
"Clean brewing unit"
Display shows
"Refill with still water or
remove filter "
Display shows
"Empty drip trays"
despite them being
empty�
52
Cause
Power failure or appliance
switched off at mains.
Container is outside the
range of the sensor�
Material e�g� milk carton is
not recognised�
Voltage too high or too low�
Appliance is too hot�
The appliance has a fault�
Beans are not falling into the
grinding unit (beans too oily)�
Brewing unit is soiled�
Too much ground coffee in
the brewing unit�
The mechanism of the
brewing unit is stiff.
Water tank wrongly inserted Insert water tank correctly
Carbonated water in the
water tank�
Float is stuck in the water
tank�
New water filter not rinsed
according to instructions, or
water filter used or defective.
Air in the water filter.
Drip tray is soiled and wet�
Emptying is not detected
when the appliance is
switched off.
Solution
Re­enter values; do not switch
the appliance off at the mains or
select the "Off" option in the Clock
display menu�
Position the container at the right
edge�
Confirm the display request with
"Yes" or use the enclosed milk
container�
Contact electricity or grid provider�
Have the power supply checked
by an expert�
Switch off appliance for
30 minutes�
Proceed according to the display
screen�
Gently tap the bean container�
Possibly change the type of
coffee. When the bean container is
empty, wipe it with a dry cloth�
Clean the brewing unit�
Clean the brewing unit� Do not
place more than two level measur-
ing spoons of ground coffee in the
drawer�
Clean the brewing unit, see the
section "Care and daily cleaning"�
Fill the water tank with fresh tap
water�
Remove the tank and clean
thoroughly�
Rinse the water filter according to
the instructions and then switch
on, or use a new water filter
Dip the water filter into water
until no more air bubbles escape,
replace the filter.
Clean and dry the drip tray
thoroughly�
When the appliance is switched
on, remove and re-insert the drip
tray�