Serato RANE SEVENTY Benutzerhandbuch Seite 18

•
Instant Dbls: Select this option to determine the default mode for each deck's Instant Doubles button:
Normal: In this mode, press the button to load the deck's track to the other deck.
o
Sync Mode: In this mode, press the button to automatically sync the deck's tempo with the other
o
deck. Hold Shift and press the button to deactivate sync.
Silent Cue: In this mode, press the button to mute the deck. You can use this feature to silence a
o
track before selecting a hot cue for playback with the Performance Pads (the deck will unmute as
the cued audio begins playing). You can also unmute the deck by holding Shift and pressing the
button (the track's playhead will be unaffected).
•
Defaults: Select this option to restore all of the settings in the Settings page to their factory default
values.
Cut-In Adjust: Select this page to enter the Cut-In Adjust setup menu:
•
Deck 1 and Deck 2: Set these between 0 and 16 to determine the amount of dead space between the
closed and open positions of the deck's fader. The higher the setting, the higher you have to push the
Channel Fader in order for any audio to be heard.
•
XFader L and XFader R: Set these between 0 and 16 to determine the amount of dead space between
the Crossfader's closed and open positions. The higher the setting, the further you have to push the
Crossfader toward the center position in order for any audio to be heard.
Flex FX: Select this page to view and edit the internal Flex FX settings:
•
Beats: Select this option to determine the increments in which the Flex FX beat division parameter can
be adjusted:
In Extended Mode, you can set Flex FX to standard timings ranging from 1/32 to 32 beats as well
o
as dotted and triplet variants of each of these timings.
In Simple Mode, which is the factory default, you can set Flex FX beats only to standard timings
o
(no triplet or dotted timings).
In No Dotted Mode, the Flex FX beats include standard timings and triplets but no dotted timings.
o
In No Triplet Mode, the Flex FX beats include standard and dotted timings but no triplets.
o
•
Echo, Reverb, Brake, Flanger, Phaser, and Delay: Select one of these pages to edit a Flex effect's
parameters. When you save a change to an effect parameter here, it will be made the default setting for
whenever you select the effect. To learn more about Flex FX parameters, see the
•
Defaults: Select this option to restore all of the Flex FX settings to their factory default values.
Software FX: Select this page to adjust how Serato DJ Pro's software effects function with the Seventy:
•
Multi FX: Setting this to On will enable you to use stacked software effects (as described in the
section).
•
Mix Flex FX: Setting this to On will enable you to combine software effects with a Flex effect (as
described in the
•
USB Insert: When set to Auto, any software effect will be muted as soon as you deselect it with the FX
button, thus decreasing overall latency (which is beneficial for scratching). When set to On, deselected
software effects may have an audible "tail" as they gradually decay (depending on the effect).
Version: Select this page to check which firmware version is currently installed on your Seventy.
Factory Reset: Select this to reset all of Seventy's settings to their factory default values.
18
Effects section).
Effects section.
Effects