Serato RANE SEVENTY Benutzerhandbuch Seite 16

Custom Pad Sets
Seventy comes with two customizable pad modes. For these modes, you can use Serato DJ Pro's MIDI
mapping feature to program the Performance Pads to trigger functions of your choosing.
To enter a custom pad mode, press either Roll or Transport so that the button lights red.
Note: You may need to set Pad > User Modes to On in the Main Menu, which you can access by holding
Shift and pressing Tap (see the
If this setting is not On, the custom pad modes will not be accessible.
To create a custom pad set:
1. While connected to Serato DJ Pro, make sure that Seventy is entered into one of the two custom pad
modes (as described above).
2. In Serato DJ Pro, open the Setup menu and select MIDI.
3. Select Seventy and make sure that Allow Serato DJ Hardware Remapping is enabled. Close the
Setup window.
4. In the main Serato DJ Pro window, click the MIDI button at the top of the screen to begin mapping.
5. Click a feature in Serato DJ Pro, then touch or move a control on your hardware to map the feature to
that control.
See the Serato DJ Pro manual for more information on MIDI mapping.
Main Menu
The Seventy comes with various settings that you can edit and save in order to customize the mixer's
operation. Settings can be edited in the Main Menu, which can be viewed on the Display.
Navigating the Main Menu
To enter or exit the Main Menu on the Display, hold Shift and press the Tap button.
To highlight pages or settings in the menu, push the FX Joystick up and down.
To select pages in the menu, press the Parameter Knob.
To go back one page in the menu, push the FX Joystick to the left.
To edit settings in one of the menu pages, turn the Parameter Knob while the setting is highlighted.
To save your changes to a setting, press the Parameter Knob while the setting is highlighted.
16
Main Menu section of this manual for more help navigating the settings).
MAIN MENU
SETTINGS
CUT-IN ADJUST
FLEX FX
SOFTWARE FX