Herunterladen Inhalt Inhalt Diese Seite drucken

Hartan Racer GT Bedienungsanleitung Seite 25

Vorschau ausblenden Andere Handbücher für Racer GT:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Quality agreement
WARRANTY CLAIM — YES OR NO?
Rust: To provide a proper basic protection of the chassis, it has undergone
a rust-proofing treatment. However, rust-stains may be found when lacking
maintenance. This case will not be covered by the warranty.
Scratches: Scratches caused by wear and tear will not be covered by the
warranty.
Mould formation: Fabric parts, having become wet, should be dried
properly to prevent mould formation (see Instructions). Mould formation
will not be covered by the warranty.
Bleaching of the fabrics: We confirm that the fabrics comply with the
established standards. It cannot be ruled out that colours of the fabrics
may fade while the parts are exposed to direct sunlight, washed too fre-
quently, come into contact with sweat and detergents, or suffer abrasive
wear (especially on those parts where the pram is handled). Consequently,
colour fading is excluded from the warranty. It is unavoidable that colours
sometimes differ slightly from one individual batch to the next, which is why
this case will not be covered under the warranty.
Knob formation on fabrics: We recommend that you apply general
clothes care. As with woollen sweaters, the knobs can easily be removed
by using a clothes-brush or burling machine.
Tearing of seams, fabrics, press studs : At the time of purchase, please
check carefully that all the fabric parts, seams and snap fasteners have
properly been sewn and fastened. In case of a possible complaint
concerning seams/defective snap fasteners, a claim must immediately
be reported to your dealer after the defect has been discovered.
Wheels: As wheels used on prams will not be balanced, they may show
slight run-outs („wobbles"). Worn tires will be regarded as natural wear and
tear. No claim can be raised if your pram, using pneumatic tired wheels,
has a „flat". This will be attributed to extraneous causes — a small hole
caused by a pointed object, or pushing the pram about when it has not got
enough air in the tire. This case will not be covered by the warranty.
21

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis