Setting The Fuel Gas Type (If Band P (Lpg) Is Used); Checking The Date And Time - Panasonic U-16GE3E5 Bedienungsanleitung

VG (gas closing valve force-closing) switch
STOP
(collective stop)
switch
N/P switch
connector

3. Setting the Fuel Gas Type (If Band P (LPG) is Used)

* When using Band P (LPG) for fuel gas, the gas type has to be configured.
* The outdoor unit power breaker remains OFF.
(1) Move the lever of the N/P switch that is attached to the mixer part of the engine to the position shown in the diagram. Turn
it 180 degrees in the anticlockwise direction (there is a stopper provided). Do not apply unnecessary force to turn it any
further.
(2) Mount the attached short-circuit connector to the
N/P switch (Fig. 1) of the outdoor control board.
* S witch on the power breaker of the outdoor unit.
(3) Apply the < Gas type set and adjusted > label in the PL NAME designated location in the electrical box.
(4) After making the setting, use an ink pen or other tool to make a mark so that the original setting position of the lever is
known.

4. Checking the Date and Time

 Checking
(1) Select the
Example:
(2) With the date displayed, press the SET key to switch to the time display.
Example:
(3) With the time displayed, press the SET key to switch back to the date display.
* If the current date and time display are not correct, reset (correct) them.
 Setting (correcting)
(1) With the date or time displayed, press and hold the SET key for 1 second to enter setting mode.
Example:
(2) Each time the SET key is pressed, the setting contents are confirmed and the first digit display changes. The settings are
as shown in Table 2. After
After installing, be sure to
check that there is no gas
leakage. There is the danger
of fire if gas leaks.
(date display) menu item to display the current date.
(April 1, 2017)
(11 h 05 m 25 s)
(2017)
is displayed for the first digit, the display returns to
HOME key
Fig. 1
Lever
When shipping
EN - 5
UP key
DOWN key
HOME UP DOWN SET
SET key
Terminating
resistor
Yes/No switch
Lever
When the Band P (LPG) is setting
Fig. 2
.