How To Pair Remote Control And Trainer - Pettec Remote Vibra Advance 2.0 Bedienungsanleitung

How to pair remote control and trainer

If your trainer does not beep when the TONE button of the remote control is pushed, or
if you feel the trainer is not responding to the remote control, follow these steps to pair:
1. With the trainer off your pet, turn the trainer off. Restart, press and hold the On/Off
button until the green LED light flashes every second on the trainer. This continues for
16 seconds, within which pairing should be completed.
2. Press and hold the TONE and VIBRA button of the remote control at the same time
until the green LED light on the trainer flashes rapidly for 5 times, indicating pairing
is completed.
Pairing second trainer
1. Set the toggle switch to 2.
2. Turn on the trainer of dog 2, press any mode buttons to verify function.
3. If dog 2 trainer does not respond, pairing may be needed. Repeat steps in How to pair
remote control and trainer.
32