Charging Receiver And Remote Control - Pettec Remote Vibra Advance 2.0 Bedienungsanleitung

Charging receiver and remote control

Lift the rubber covers protecting the remote control / trainer charging jack. Connect the
charger connectors to the remote control and the trainer charging jack, as shown below.
Connect the USB port to the charging adapter. Plug the charger into a standard wall outlet.
Charge the unit for 4 hours for the first charge. Recharges take only 2-3 hours. When char-
ging is completed, remove the charger connector.
Note: The battery indicator on the remote control will scroll and the indicator light in stea-
dy red while charging; the battery indicator will become steady, and the LED indicator light
flashes when fully charged. The indicator light on the trainer will be in steady red while
charging and green light turns on when fully charged.
31