Specifications; Remote Control - Pettec Trainer Advance 2.0 Handbuch

SPECIFICATIONS

Features
600m range
Additional sound signal
IPX7 waterproof
Facts
Receiver collar
Dimensions 3.4 x 7.6 x 3 cm
Weight 109g
Length Collar
*2 dogs trainable with one remote.
20
Up to 10 days battery life
16 vibration levels
Expandable by additional collar*
Remote
15 x 4.9 x 2.2 cm
80g
22 - 67 cm
OPERATION GUIDE

Remote control

The blue backlight on the display stays on for approximately 30 seconds after a button
press. After that with no button press, the blue backlight shuts off first, and if no button is
pressed within another five minutes, the display shuts off and the remote control goes into
battery conversation mode. Pressing any button will turn the display back on.
Trainer
To turn the trainer on, press and hold the On/Off button until the green LED light comes
on. Release the On/Off Button and if the trainer is in normal mode, the green LED will
flash once every five seconds, indicating the trainer is on and ready to receive a signal
from the remote control. To turn the trainer off, press and hold the On/Off button until
the red LED light shuts off. (This takes approximately three seconds) After that release
the On/Off button.
Note: To extend the life of the batteries, turn the trainer off when it is not in use.
21