Klarstein Kraftwerk Smart 10 Handbuch Seite 35

If you wish to operate the unit without the need to empty the water tank, please:
• Remove the drain knob and rubber plug and retain for future use.
• Connect the drain tube supplied to the water outlet as shown and locate the other
end into a drain.
The drain tube may be extended by adding an extension tube and using a suitable
connector.
Please note :
1. The drain must be at or below the outlet level.
2. Flashing 'full water' indicator will not function in this mode of drainage.
3. If you want to extend the water tube, you can connect it with another tube (OD:
18 mm).
EN
35