Reely 2103650 Bedienungsanleitung Seite 42

Function
1 Drive function
2 Brake
3 Low voltage protection
4 Start mode
5 Maximum brake force
The greyed out values are the default settings after a reset (see chapter 9. c). The speed controller of your
vehicle may have a different default setting upon delivery; then note the flashing signals of the red LED and
the respective beeps.
Overview of functions:
• Function #1, green LED flashes one time briefly: Drive function
The speed controller can be switched between "Forward / Brake" and "Forward / Brake / Reverse" here. For the
motorcycle, the setting "Forward / Brake / Reverse" must not be used.
• Function #2, green LED flashes two times briefly: Brake
If you release the throttle on the transmitter or move the throttle/brake lever on the transmitter back to the neutral
position, the vehicle will slow down by itself. The effect is just like the engine braking function on a "real" motorcycle
when you release the accelerator pedal without pressing the brake pedal. The brake functions like a brake on a
standard electric motor (a brushless electric motor does not have strong magnets that slow down the rotor).
• Function #3, green LED flashes three times briefly: Low voltage protection
When operating the motorcycle with a LiPo drive battery, the low voltage protection must be switched on (we recom-
mend that you do not change the default setting of 3.2 V / cell).
A fully charged 2-cell LiPo battery has a voltage of approximately 8.4 V. If a cut-off voltage of 3.2 V / cell has been
programmed, the speed controller switches off the engine when it has a voltage of 6.4 V for 2 seconds (2 cells x
3.2 V). This prevents harmful deep discharge of the LiPo battery.
• Function #4, green LED flashes four times briefly: Startup mode
The vehicle will start to move with more or less force depending on the setting. The higher the setting value, the
more current the engine draws from the connected rechargeable battery; so the rechargeable battery must be
high-performance. A higher setting should also be used only on loose ground, otherwise it will overload the drive
(gears, drive chain, tires).
• Function #5, green LED flashes five times briefly: Maximum brake force
The speed controller offers a proportional brake force depending on the position of the transmitter lever. The maxi-
mum brake force at full deflection is adjustable between 25%, 50%, 75%, and 100%. A high setting (e.g., 100%)
reduces the braking distance, but has a negative impact on the life of the drive (drive pinion, main gear, drive chain).
42
Green LED Red LED flashes.... (+ Beep)
flashes...
1x short 2x short
(+ Beep)
1x short Forward/ Forward/
brake brake/
reverse
2x short 0% 5%
3x short Off 2.6 V/cell
4x short 1 (slow) 2
5x short 25% 50%
3x short 4x short 1x long
10% 15% 20%
2.8 V/cell 3.0 V/cell 3.2 V/cell
3 4
75% 100%
1x long, 1x long, 1x long,
1x short 2 short 3 short
25% 30% 40%
3.4 V/cell