gefran SBI-DCP-33 Bedienungsanleitung Seite 11

A5
A1: fasten the supports B and spacers D to the
SBI-DCP33 card as shown in the figure
A2: remove the 4 screws as shown
A3: fit the SBI-DCP33 card under the regulation
card by tightening the screws A on the suppor-
ts B and insert the spacers in the 2 holes.
A4: replace the regulation card and fasten this in
place using the 4 screws.
A5: insert the terminals of the cable E into the XR
connector (expansion card) and into the fema-
le XENC connector (regulation card)
A6: replace the covers of the drive
B - SBI-DCP33 card on the regulation card. Use the supports (C)
and screws (A) supplied with the card.
B1 B2
B4 B5
B1: cut the card along the dashed line
B2: remove the 2 screws from the regulation card
B3: insert the terminals of the cable E into the XR connector
(expansion card) and into the female XENC connector (regula-
tion card)
B4/B5: fix the two supports C, position the optional card and fasten
it in place using the screws A.
B6: replace the covers of the drive
ENGLISH -