Bresser TemeoTrend LB Bedienungsanleitung Seite 30

search. If the temperature goes above or below than the temperature
measuring range of the main unit or the remote unit (stated in specifi ca-
tion), the display will show „
4b) HOW TO READ THE KINETIC WAVE DISPLAY
The kinetic wave display shows the signal receiving status of the main
unit. There are three possible forms:
The unit is in searching mode.
Temperature readings are securely registered.
No signals.
4c) MAXIMUM AND MINIMUM TEMPERATURES
The maximum and minimum recorded indoor temperature, outdoor
temperatures will be automatically stored in memory.
To display them, Press [MEM] once to display the maximum readings.
The respective indicators,
[MAX] or [MIN] will be displayed.
To clear the memory, hold down [MEM] for two seconds.
The maximum and minimum readings will be erased.
If you press [MEM] now, the maximum and minimum readings will
have the same values as the current ones until different readings are
recorded.
4d) DISCONNECTED SIGNALS
If without obvious reasons the display of the outdoor temperature goes
blank, hold [▼] for two seconds to enforce an immediate search.
If that fails, check:
1. The remote unit is still in place.
2. The batteries of both the remote unit and main unit. Replace as
necessary.
"
30