Leuze electronic OGS 600 CN-M12-Serie Bedienungsanleitung Seite 19

NOTE
Shielding connection!
The shielding is connected via the M12 connector housing. Additional shielding
is not required for sensors with M12 connection.
NOTE
Protective Extra Low Voltage (PELV)!
The device is designed in accordance with protection class III for supply with
PELV (Protective Extra-Low Voltage).
NOTE
Further information on electrical connection, on configuration and on commis-
sioning can be found in the operating instructions beginning in chapter 5.
Decommissioning, maintenance
CAUTION
 Do not open the device yourself under any circumstances! The housing of the
sensor contains no parts that need to be adjusted or maintained by the user.
If faults cannot be cleared, the device should be switched off and protected
against accidental use.
 Package the device for transport and storage in such a way that is protected
against shock and humidity. Optimum protection is achieved when using the
original packaging. Ensure compliance with the approved environmental con-
ditions listed in the specifications.
 Do not use aggressive cleaning agents such as thinner or acetone for clean-
ing the device.
EN
19