Leuze electronic OGS 600 CN-M12-Serie Bedienungsanleitung Seite 15

Safety
This sensor was developed, manufactured and tested in line with the applicable
safety standards. It corresponds to the state of the art.
Intended use
The OGS 600 optical guidance sensor measures the contrast of a guide trace that
is affixed to the ground. The sensor supplies the vehicle's position data on the
guide trace, which determines the course of travel.
Areas of application
The OGS 600 optical guidance sensor is designed for the following area of appli-
cation:
- Intralogistics – in-house material flow with automated guided vehicles (AGV).
CAUTION
Observe intended use!
The protection of personnel and the device cannot be guaranteed if the device is
operated in a manner not complying with its intended use.
 Only operate the device in accordance with its intended use.
 Leuze electronic GmbH + Co. KG is not liable for damages caused by
improper use.
 Download the operating instructions for the device at www.leuze.com.
 Read this supplement and the operating instructions for the device before
commissioning the device. Knowledge of these documents is required in
order to use the equipment for its intended purpose.
NOTE
Download operating instructions from the Internet!
 Call up the Leuze home page: www.leuze.com.
 Enter the type designation or part number of the device as the search term.
 The operating instructions can be found on the product page for the device
under the Downloads tab.
NOTE
The integrated illumination of the optical guidance sensors of the OGS 600 series
is classified as follows:
 Illumination red:
risk group 0 (exempt group) in acc. with EN 62471
EN
15