Twisted Pair (Utp) Connector - Santec VTC-HDH359IRPU/G Bedienungsanleitung

Bedienungsanleitung / User Manual
VTC-HDH359IRPU/G / VTC-HDH359IRPU/W

1.4 Twisted pair (UTP) connector

The camera is equipped with a RJ-45 system connector. Hence the following is possible:
remote power supply, UTP (twisted pair) of the video signal and OSD parameterising via RS-
485. The communication is done via the Pelco D protocol. The command to open/close and
to confirm the camera OSD is "Open iris". Use the keyboard joystick and move it
up/down/left/right to navigate through the OSD menu.
RJ-45 system connector: Pin assignment:
If no RJ-45 connector is to be used, there is a RJ-45 screw terminal adapter (included in the
delivery) with connections for UTP video, RS-485 and DC power jack.
In addition, there is a video signal via BNC plug (for direct connection of 75 Ohm coaxial
cables).
Separate RJ-45 screw terminal adapter:
UTP (twisted pair) connector:
1. Video +
2. Video –
RS-485 connector:
3. RX +
4. RX –
_________________________________________________________________________________
Pin:
1 Video UTP
2 Video UTP
3 RS-485 +
4 Power supply – or ~
5 Power supply + or ~
6 RS-485 -
7 Power supply + or ~
8 Power supply – or ~
- 33 -
DC power jack