Seav BeWeather-Serie Bedienungsanleitung Seite 12

using the special terminal on the con-
trol unit, as illustrated in the connection
diagram.
- For the radio receiver to operate cor-
rectly when two or more control units
are used, we recommend that you
install the devices at least 3 metres
away from each other.
The below products:
BeWeather Series
are in compliance with the specifics of
RED 2014/53/EU, EMC 2014/30/EU, LVD 2014/35/EU
Directives.
TECHNICAL DATA:
- Power supply
- Motor output
- Operating temperature
- Radio receiver
- Compatible radio controls
- Anemometer sensitivity
- Sun sensor sensitivity
- Number of codes that may be stored
- Packaging dimensions
- Container
: 230V~ 50/60Hz 600W max.
: 230V~ 500W Max.
: -10 ÷ 55 °C
: see model
: 12-18 Bit or Rolling Code
: 5 ÷ 40 Km/h
: 5 ÷ 40 Klux.
: 10 Max.
: 240x185x110 mm.
: PC UL94V-0 ( IP54 )
CONNECTION OF CN 1 TERMINAL BOARD:
1: Earth.
2: 230 V line input (Phase).
3: 230 V line input (Neutral).
4: Upward movement motor output.
5: Shared motor output.
6: Downward movement motor output.
INITIAL OPERATING CONDITION
The device can only operate in conjunction with one or more radio controls. There is no radio
control code stored in the default factory setting.
OPERATION USING DIFFERENT MODELS OF RADIO CONTROL
Different models of radio control may be programmed. By storing a code (1 button) a cyclic
step-by-step operation (Up-Stop-Down) may be achieved, and by storing two different codes (2
buttons) different commands are produced, one for Up and one for Down. Storing three differ-
ent codes (3 "BeFree" series buttons) produces three different commands: the first for Up, the
second for Stop and the third for Down.
Operation using a 1-button radio control:
The following type of operation is obtained using a radio control with a single button: the
first press controls the upward movement of the shutter until the motor timer stops. The
second press controls the downward movement of the shutter. If the button is pressed
before the motor stops running, the control unit will stop the shutter moving and the
button will need to be pressed again to reactivate the motor in the opposite direction.
Operation using a 2-button radio control:
By using a radio control with 2 buttons, the following processes may be carried out: the
first button ("Up") controls the upward movement, until the motor has stopped running,
and the second button ("Down") controls the downward movement of the shutter. If the
upward movement is interrupted with another "Up" command, the motor will continue to
run in the upward movement direction. If, however, the movement is interrupted with a
"Down" command, the control unit will stop the motor.
The procedure remains the same for the downward movement phase.
Operation using a 3-button radio control (BeFree x1):
The following type of operation is obtained using the BeFree x1 radio control: the (Up)
button controls the upward movement until the end of the motor time, the (Stop) button
causes all movement to stop and the (Down) button controls the downward movement.
If a stop command is sent during the upward or downward movement, the control unit
causes this movement to stop. If a command that is in the opposite direction to the current
movement is sent during the upward or downward movement, the control unit causes the
shutter to change direction.
12