Seav BeWeather-Serie Bedienungsanleitung Seite 11

network and is not equipped with any
type of 230 V a/c electric line section-
ing device. The installer is responsible
for installing a sectioning device in the
system. An omnipolar switch with over-
heating category III must be installed. It
must be positioned in such a way that it
is protected against accidental closures.
- For connections (power supply and out-
let contact) we recommend the use of
flexible wires with an insulating sheath
in harmonised polychloroprene (H05RN-
F). The wires should have a minimum
cross-section of 0,75 mm
- Fasten the connection cables using the
cable clamp supplied with the product kit.
- Handle the control unit with care dur-
ing the installation process and make
sure that all components are properly
assembled. Pay particular attention to
the ceramic plate and the flat connec-
tion cable. When closing the box again,
it must fold back on itself normally.
- It is very important to establish an exact
location so that the product is exposed
to weather conditions it can control.
- Fix the device to the wall using the
screws and rawlplugs supplied with the
product, in the correct position (see fig-
ure below).
- Do not paint or varnish the sensitive
surface of the control unit.
- The dirt which accumulates on the sur-
face of the rain sensor restricts its sen-
.
2
sitivity: we therefore recommend that it
is cleaned once or twice a year using a
damp cloth, after the electricity supply
has been disconnected.
- Connect the earth wire of the motor to
the earth wire of the electrical system
11