After Every Use; Cleaning / Hygiene Requirements; Water Tank - Nevadent NMD 3.7 B4 Bedienungsanleitung

10. When no more water is coming out of
the nozzle 1, the water tank 19 is emp-
ty. Switch off the dental water jet 12
and replenish the water tank. When the
device is switched on again, the device
will automatically start on the last select-
ed water jet setting.
11. To switch off the dental water jet 12,
press the on/off switch
take the nozzle 1 out of your mouth un-
til the dental water jet has been
switched off.

8.5 After every use

1. Open the cover over the filling open-
ing 18, pour out the remaining water
from the water tank 19 and close the
cover again.
2. Switch on the dental water jet 12 for a
few seconds with the on/off switch
remove any remaining water from the pipes
inside the dental water jet.
3. Hold down the release button 5 and
gently pull the nozzle attachment 2 up-
wards.
4. Rinse the nozzle attachment 2 under
running water and insert it into a hol-
der 13.
5. Place the dental water jet 12 on the
battery charger 15.
NOTE: it is advisable to replace the nozzle
attachments 2 every 12 months (see "Order-
ing accessories" on page 25).
9. Cleaning / Hygiene
6. Do not
Nozzle attachments
1. Hold down the release button 5 and
6 to
2. Rinse the nozzle attachment 2 under

Water tank

Clean the water tank 19 once a week or be-
fore you are not going to use the device for
more than one week.
1. Figure D: push the water tank 19
2. Rinse the water tank 19 thoroughly
3. Dry the water tank 19 on the outside
NOTES:
•
•
requirements
DANGER! Risk of electric
shock!
Before cleaning the battery charger 15,
pull the mains plug 17 out from the
mains socket.
Do not immerse the dental water jet 12
and/or the battery charger 15 in wa-
ter!
The battery charger 15 must be com-
pletely dry before you reconnect it to the
wall socket.
gently pull the nozzle attachment 2 up-
wards.
running water and insert it into a hold-
er 13.
downwards off the dental water jet 12.
both inside and out with warm water.
and pour out the remaining water.
if you are not going to use the dental
water jet 12 for more than one week,
allow the water tank 19 to dry com-
pletely before you put it back into the
dental water jet.
It is also recommended that the device
be disinfected at regular intervals. Spe-
cial disinfectant powders and prosthe-
sis cleaners are suitable. Dilute the
solution with water and place it into the
23
GB