Software Installation; Usb Driver - Brunner Cls-E Rudder Kurzanleitung

3 SOFTWARE INSTALLATION

5

USB DRIVER

USB Driver is installed automatically when power is applied the first time.
CLS-E Rudder must show up in Windows as Game Controller «CLSE Rudder» (standalone
mode). Run any flight simulator program and map the z-axis to yaw.
Optionally assign x-rotation axis to left brake and y-rotation axis to right brake.
CLS2SIM (V 4.9 or later)
For enabling additional Control Loading Features download CLS2Sim (Win32 application)
from http://www.brunner-innovation.swiss/media
If the optional CLS2Sim Software is installed all axes are mapped by the software auto-
matically.
IN THE CASE THAT CLS2SIM IS USED, THE USB YAW AND BRAKES MAPPING
FOR THE CLS-E RUDDER MUST BE DISABLED IN THE SIMULATION SOFTWARE.
DUAL RUDDER SETUP / SYNCHRONIZATION
In case of 2 CLS-E Rudder (MCC Configuration) connect a standard
RJ45 Cat5 Ethernet cable on the "CANopen" connector between the
units (See Chapter 5 Wiring Diagram on page 27).
All necessary settings for self synchronization is done automatically
at the first power up of the devices.
Read the manual and help file in CLS2Sim for additional information.
Contact us under following e-mail in case of troubles
or questions info@brunner-innovation.swiss