EINHELL Bavaria BSM 500 Gebrauchsanweisung Seite 6

Anl BSM 500_SPK1:_ 14.06.2007
GB
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
Safety regulations
The corresponding safety information can be found
in the enclosed booklet.
Proper use
The drill is designed for drilling holes into wood, iron,
non-ferrous metals and rock using the appropriate
bits.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
Description (Fig. 1)
1 Quick-change drill chuck
2 Depth stop
3 Additional handle
4 Selector button: drill/hammer
5 Selector button:
clockwise/anticlockwise
6 Speed control
7 Locking button
8 On/Off switch
On/Off switch (Fig. 1):
To switch on: Press switch 8
Continuous operation: Lock switch 8 with locking
button 7
To switch off: Press switch 8 briefly
6
16:26 Uhr Seite 6
The speed is varied by applying more or less
pressure on switch 8. You can preselect the speed
by turning the knurled screw in switch 8.
Selector button: drill/hammer (Fig. 2)
Please note: This switch should be
in ʻdrillʼ position when drilling holes in tiles.
Position A: Rotary switch set for hammer mode.
Wait for the drill to stop before
changing!
Position B: Rotary switch set for drilling mode.
Wait for the drill to stop before
changing!
Technical data
Voltage: 230 V ~ 50 Hz
Power rating:
Drilling capacity Concrete 13 mm
Steel 13 mm
Wood 25 mm
No Load Speed 0 - 3000 min
Safety insulated
Sound pressure level L
pA
Sound power level L
WA
Vibration a 8,96 m/s
hv
Weight
Caution
The BSM 500 is not designed for the operating of
auxiliary devices.
Do not use near steams or inflammable liquids.
Only use sharp bits and suitable screwing bits.
Remove the plug from the socket for all adjusting
and cleaning work.
Protect the mains cable against any damage. Oil
and acids can damage the cable.
Do not carry the device by the mains cable.
Do not remove the plug from the socket by
pulling the mains cable.
Make sure before inserting the plug that the
operating switch is not locked.
When using a cable drum uncoil the cable
completely. Cross-section of wire at least 1,5
mm 2 .
Do not overload machine.
500 W
-1
II /
90 dB
101 dB
2
1,8 kg