How To Adjust Focus With The Focus Assistant - Axis Q16 serie Installation

Replace the lens
1. Stop all recordings and disconnect power from the product.
2. Disconnect the lens cable and remove the standard lens.
3. Attach the new lens and connect the lens cable.
4. Reconnect the power.
5. Log in to the product's webpage, go to the Image tab and then select the P-Iris lens
you have installed.
Note
If you use a DC iris lens, select Generic DC Iris.
6. For the changes to take effect, you need to restart the device. Go to System >
Maintenance and click Restart.
7. Adjust the zoom and focus.
How to adjust focus and zoom for optional lenses
If the camera is mounted so that you cannot look at the image and access the lens at the same
time, use the Focus Assistant, see How to adjust focus with the Focus Assistant on page 21.
1. Go to the Image tab in the product's webpage.
2. Click Autofocus
3. Loosen the zoom and focus pullers on the lens by turning them counter-clockwise.
See Product overview on page 8.
4. Move the pullers to set zoom and focus and check the quality of the image in the image
window.
5. Re-tighten the zoom and focus pullers.
6. Click Autofocus.

How to adjust focus with the Focus Assistant

Note
Only valid for optional P-iris, DC-iris or manual iris lenses.
• The view in front of the camera should not be changed during focus adjustment. If the
camera is moved, or if a finger or other object is placed in front of the lens, restart the
procedure.
• If movements in front of the camera cannot be avoided, the Focus Assistant should not
be used.
1. Mount or place the camera so that it cannot be moved.
2. Loosen the zoom puller by turning it anti-clockwise. Move the puller to set the zoom
level. Retighten the zoom puller.
AXIS Q16 Network Camera Series
21
EN