Special Features Of Carbon; Care Instructions For Carbon Components - Coboc TEN Torino Bedienungsanleitung

56
Furthermore, carbon parts need regular visual inspections. Check if single
layers like paint, finish or fiber are detaching. Look for changes on the sur-
face of the according parts, like chipping, holes or deep scratches. Make
sure to check if the components are getting softer or less stiff and solid.
If this is the case with one or more components, they should be replaced
immediately.

Special features of carbon

Carbon fiber reinforced plastic is a lightweight material that has very spe-
cific properties. Understanding these properties is mandatory in order for a
hazard-free use and a long operation without defect.
Carbon can be used to build extremely lightweight high-strength and
robust bicycle components, if processed correctly.
However, a disadvantage of this material is, that possible damages might
not be visible from the outside right away, as carbon does not deform
at overload like aluminum or steel might do. The material might keep its
shape even tough the inner structure is already damaged. A damaged
structure influences stability of the component and therefore might lead to
serious falls and injuries. If you have concerns regarding the condition of
one of the carbon components, make sure to visit your Coboc dealer.
If you hear pops, this might indicate defect on a carbon
component. Check the screw fittings on your carbon components
for correct torque regularly. Should there still be audible pops,
make sure to contact your Coboc dealer. Under no circumstances should
you continue using the damaged component.
Carbon components should never be heated up to high
temperatures, as would be the case for powder coating or
stove-enamel finishes. The appearing heat might damage compo-
nents. Also avoid storing your bike in a vehicle that is exposed to strong
sunlight.
Maintainance & Care

Care instructions for carbon components

Clean your carbon components with a soft cloth and clear water. If that
should not be enough you might add some detergent or use a petro-
leum-based cleaner.
Never use degreasers containing acetone, methyl chloride or
trichloroethylene. Chemical or not neutral cleaners that contain
solvents could attack the surface and therefore weaken the
component.
Lightweight carbon parts may be exposed to increased wear.
Please follow the instructions on service intervals and have your
carbon components checked for defect or wear regularly by your
Coboc dealer.
Carbon components should never be greased. Doing so leads to
grease entering the surface, which makes tight clamping within
the permitted torque value impossible. We recommend using
carbon paste instead, as increased friction makes less torque value
necessary to clamp safely.
Check your carbon components for optical damage such as
notches, dents, tears, discoloration, etc, Should you notice any of
these defects, make sure to contact your Coboc dealer and
refrain from using your TEN Torino until doing so.