Handling; Operating The Coboc Electric Drive - Coboc TEN Torino Bedienungsanleitung

Before Every Ride
Checking the wheels
Check the wheels and tire pressure! Inspect the tires and rims for abrasion,
damage, tears, deformations or smaller pieces that might be pushed in
(e.g. glass fragments or nails). We advise you to use a suitable bicycle
pump with built in pressure gauge. The optimal tire pressure is indicated
on the side of the tire and may differ depending on the tire model. In case
of doubt, or if you use components other than those already built in as
standard, please refer to the tire manufacturer, to ask for the correct tire
pressure. If tire pressure is too low, there is an increased risk of having flat
tires due to rims pressing through the tire. Furthermore this might cause
sustainable damage to the rim.
If the pressure is too high, tires or rims might be damaged. In any case,
wrong tire pressure might cause crashes.
If you are not sure whether your Coboc bike is in technically safe
condition, do not start your ride. Let your local Coboc dealer or a
service partner check your bikes condition.
The minimum air pressure for your TEN Torino must not be fallen
below. Riding with too little air pressure can damage the rim.
If you use your Coboc bike extensively then make sure to have your bike
checked more regularly from your Coboc dealer or a service partner (s.
chapter Maintenance & Care).
Before your ride, make sure that your battery level is high enough
for the intended journey (s. chapter Battery & Charger).

Handling

We assume that as a Coboc bike user you have gathered enough basic
experience with ordinary bikes. If this is not the case, we recommend prac-
ticing on a bike without motor support. Because of the strong acceleration
and the increased maximum speed it is recommended for you to be able
to handle bikes very good.
Get used to your Coboc bike. The special riding characteristics for Coboc
bikes require for you to familiarize with it on different terrain. Make sure
that you got it under control before starting to use your Coboc bike in
public.

Operating the Coboc Electric Drive

Your TEN Torino has two operating modes:
"Bike off" / manual riding: You can always choose to ride your bike with-
out motor support. Motor support is turned off, if the five LEDs on the top
tube are not lit up. You should keep motor support turned off, if storing or
not using your Coboc bike.
"Bike on" / riding with motor support: Pressing the power button turns
on motor support for your Coboc bike. Motor support is turned on, if the
five LEDs on the top tube are lit up. In a turned on state LEDs indicate the
battery level and motor support goes up to maximum speeds of 25 km/h.
To turn your bike back off, just press the power button again in "bike on"
mode. Your Coboc bike turns off automatically after staying unused for
more than three minutes.
49