Attachments - Sanitas SMA 40 Gebrauchsanweisung

– Do not exert heavy pressure and always guide the attachments carefully
over the surface to be treated.
– Move the instrument under light pressure in circular movements slowly
over the parts to be treated.
– Note that the cutting attachments will have a reduced effect if the skin is
softened or moist. For this reason, do not carry out any pretreatment in a
bath.
– Do not remove all the callus skin in order to retain the natural protection of
the skin.
– Always ensure that the spindle can rotate freely. It must never be perma-
nently jammed, otherwise the instrument will become too hot and suffer
damage.
– After every use, apply moisturizing cream to the parts treated.
!
Important:
Check the results during treatment. This is particularly impor-
tant for diabetics, since their hands and feet are less sensitive.

3.2 Attachments

As these are attachments for use by professionals, we would ask you to
handle them with care as they can cause injury when used incorrectly. Parti-
cular caution is advised at higher speeds.
1 – Sapphire disk
Filing and treating the nail. The specific aspect of this
sapphire disk is that only the inner disk rotates, while
the outer support is stationary. This enables precise
filing of the nails without the risk of burning the skin
with the fast rotating disk.
2 – Cylindrical milling cutter
Grinding of lignified foot nail surfaces as well as
smoothing of these. For this purpose, apply the milling
cutter horizontally to the nail surface and remove the
unwanted layer of nail using slow circular movements.
12