Control Board/Lcd Menu; Blackout-Socket - Futurelight 300 Bedienungsanleitung

Control Board/LCD menu

When there is no DMX signal, there are two running modes:
Sound-controlled mode when there is no DMX signal. To select this function, first
No DMX
disconnect DMX connection, then press encoder and turn it counter-clock-wise.
Sound
Press it again to confirm.
Automatic program mode when there is no DMX signal. To select this function, first
No DMX
disconnect DMX connection, then press encoder and turn it clock-wise. Press it
Auto
again to confirm.
DMX address:
To set DMX address for the device, press the encoder and turn it clock-wise to
Addr
increase the value and counter-clockwise to decrease it. Press encoder again to
001
confirm.
Pan/Tilt reverse:
Reverse Tilt Reverse. Press encoder and turn it counter-clock-wise. Press it again to
Tilt Y confirm.
Reverse
Tilt Obverse. Press encoder and turn it clock-wise. Press it again to confirm.
Tilt N
Reverse Pan Reverse. Press encoder and turn it counter-clock-wise. Press it again to
Pan Y confirm.
Reverse
Pan Obverse. Press encoder and turn it clock-wise. Press it again to confirm.
Pan N
Chase speed:
To set Chase Speed, press encoder and turn it clock-wise to increase the value
Chase
(faster) and counter-clockwise to decrease the value (slower). Press it again to
Speed001
confirm.
Control LED:
Red: Power on
Yellow: DMX Out (Sound/Auto mode)
Green: DMX In

Blackout-socket

If you wish to lock the light output - e.g. via an optional footswitch (Blackout-mode) or an Easy-2 remote
control, connect your footswitch or Easy-2 remote control via a mono-jack plug to the Blackout-socket.
Contact closure between tip and sleeve is reached when the footswitch is employed.
27/63 00030934.DOC, Version 1.3