Use Of The Coffee Grinder; Starting Up The Machine; Grinding Cycle; User Level Programming Mode - 969.Coffee 969-64 On DEMAND Handbuch

USE OF THE COFFEE GRINDER

KEY FUNCTION
KON/OFF Turn machine ON/OFF
Starts grinding of single dose
K1 (-)
Starts grinding of double dose
K2 (+)
KPROG
USER and TECHNICIAN programming mode

STARTING UP THE MACHINE

Press the main switch (8) to start up the system.
The machine turns on or off depending on its status at the time the main switch is pressed.
The machine is not ready for grinding when it is off (connected to the mains but OFF).
You need to press the KON/OFF key to turn ON the machine and start grinding. When the machine is ON, this appears on the
screen:
To turn off the machine (OFF-STANDBY), simply press the KON/OFF key.

GRINDING CYCLE

Press the K1(-) key to start a single dose grinding cycle. Press the K2(+) key to start a double dose grinding cycle. When the
timer ends, the motor is deactivated and you can start a new grinding cycle. You can stop a grinding cycle in progress before
the timer has ended by pressing the dose key of the relative cycle or the KON/OFF key. You can start continuous grinding by
pressing and holding the K1(-) and K2(+) keys at the same time for about 3 seconds. Press the KON/OFF key to stop grinding.

USER LEVEL PROGRAMMING MODE

The machine needs to be ON for entering user level programming mode. Press and hold the KPROG key for about 3 seconds
until this message appears:
PROGRAMMING FUNCTION
Exit programming mode
Decrease value (-)
Increase value (+)
Select and edit data
15