Cocraft HT 10 Original Bedienungsanleitung Seite 9

NOTE! Assembly see page 54
Instructions for use
• Make sure that the saw is completely intact and correctly assembled before commencing work.
• Check that the saw blade is vertical (90°) and is not set higher than is necessary to just manage to saw through
the thickness of the workpiece.
• Regularly check that all nuts and bolts are tight.
On/off switch
Plug the mains lead into a wall socket.
Switching on: Push the green button [ I ] to switch the saw on.
Switching off: Push the red button [ 0 ] to switch the saw off.
No-volt release switch
The saw is equipped with a no-volt release switch which prevents it from starting automatically when the power comes back
on following a power cut. Once power has been restored the saw must be switched on again by pressing [ l ].
Overload safety cut-out
If the motor is overloaded due to incorrect workpiece feed or the saw blade being obstructed
by debris, the overload cut-out may be triggered.
If the overload safety cut-out switch is triggered:
1. Unplug the mains lead and let the saw cool down for at least 10 minutes.
2. Make sure that no contaminants hinder the rotation of the saw blade, brush off and
vacuum saw dust as and when required.
3. Press the overload cut-out reset button (16).
4. Switch the saw on by pressing [ I ].
Rip fence
Place the rip fence onto the guide rail
and lock it in place by lowering the
locking lever.
You can also decide yourself on which
side of the blade you want to place the
rip fence, to the left or right.
Loosen the wing nuts and remove the rip
fence from the rail. Position the rip fence
in the desired position and tighten
the wing nuts.
The rip fence can be attached in two ways, with the high side or the low side
facing the blade. The low side makes it easier to handle thin material such as
plywood.
9